Yamaha DSP5D Owner's Manual - Page 131

Using MIDI remote channels Here's how to recall banks A-D to which you assigned MIDI messages, and operate MIDI remote channels. 1 In the DISPLAY ACCESS section, press the [MIDI/REMOTE] key several times to access the following MIDI REMOTE screen. MIDI REMOTE BANK SELECT area 4 Operate the appropriate channel strip. MIDI messages will be transmitted from the corresponding MIDI port. 5 To disable the MIDI Remote function, turn off the ASSIGN TO CH STRIP SECTION buttons. Note • When the MIDI Remote function is enabled, the controllers will return to their normal state if you switch to another screen. However when you come back to the MIDI REMOTE screen, the remote function of the controllers will be enabled. • The controller values during MIDI Remote operation are included in the scene data. This means that when you recall a scene, the controller values will change and MIDI messages will be transmitted. Recall Safe settings can also be applied to the MIDI Remote function. 2 In the BANK SELECT area at the upper right of the screen, use the A-D buttons to select the bank you want to use. 3 In the upper middle of the screen, use the ASSIGN TO CH STRIP SECTION buttons to select the MIDI remote channel you want to control. (Multiple simultaneous selections are allowed.) INPUT CH STIN/FXRTN INPUT channel strip 1-24 ST IN/FX RTN channel strip 1-4 This setting applies to all four banks. Turning on a button will enable the MIDI Remote function; the corresponding channel strip will function as MIDI remote channels. (The usual function of the controllers will be disabled.) At this time, the lower part of the display will indicate "REMOTE" in the encoder/fader mode area. The INPUT CH layer and ST IN/FX RTN layer indications will change to the corresponding MIDI remote channel. Encoder/fader mode area INPUT CH layer ST IN/FX RTN layer 16 Remote control PM5D/PM5D-RH V2 / DSP5D Owner's Manual Operating section 131