Yamaha DSP5D Owner's Manual - Page 170
PLUG-IN screen, GEQ function, GEQ PARAM (GEQ parameter) screen
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
GEQ function PLUG-IN screen In this screen you can make settings for Waves Y96K plugin DSP cards installed in slots 1-4. For details on operation, refer to the Y96K operating manual. PLUG-IN GEQ function GEQ PARAM (GEQ parameter) screen Here you can adjust the boost/cut for a 31-band graphic EQ or 8-band parametric EQ, specify the input/output patching, and assign a GEQ to faders. GEQ PARAM Please note that Y96K cards will operate as follows. • Settings will be stored/recalled as scene data, but the Undo function is not supported. • If you power the PM5D off and then on again, the conventional scene data will be in the state of when the power was turned off, but the Y96K will be in the state that was last stored or recalled. • If you recall a scene that produces a major change in the Y96K's settings, the Y96K's settings will change several seconds after recall occurs on the PM5D. If you want to match this timing, set the appropriate START OFFSET in the FADE TIME screen. • Do not execute scene store or recall operations while the screen indicates that the Y96K is waiting to update. If you do so, the screen will become inoperable for up to 30 seconds. • The Y96K's settings will be saved in the PM5D when you store the scene. If in the past you had stored a scene with a Y96K installed, and you then once again store that scene without the Y96K installed, the previous Y96K settings will remain. If there is a scene for which a Y96K has never been installed, and you install a Y96K and then recall that scene, nothing will be reflected in the Y96K. • In PREVIEW mode, the PLUG-IN screen will not show the state of the Y96K. Note The DSP5D does not support the Y96K. GEQ PARAM 12 3 4 5 67 A Module select This selects the GEQ module to operate. To switch between modules, place the cursor here and turn the [DATA] encoder, or click the / buttons at left or right. B LINK button This button links adjacent odd-numbered → evennumbered graphic EQ modules. When you turn this button on, a window will appear, allowing you to select whether the parameters will be copied from one module to the other, or whether both modules will be initialized. 170 PM5D/PM5D-RH V2 / DSP5D Owner's Manual Reference section