Yamaha DSP5D Owner's Manual - Page 240
Cue/solo Screen, Level Meter, Monitor / Cue Delay, Monitor Level, Monitor Out, Solo On/off, Cue Mode
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 240 highlights
MON/CUE function CUE/SOLO screen Here you can make settings and perform operations J related to the Cue/Solo function. CUE/SOLO L K M J Level meter These peak level meters indicate the level of the output signal from the MONITOR OUT jacks. You can select the level detection point to be immediately before the delay that is provided on the MONITOR/CUE bus output (when the PRE DELAY button is on) or immediately after the delay (when the POST DELAY button is on). K MONITOR / CUE DELAY Here you can make settings for the delay function provided on the MONITOR/CUE bus output. Use the knob to specify the delay time (0-1000 msec), and use the ON/OFF button to switch the delay on/off. If the ON/OFF button is on, the monitor signal and cue signal will be delayed by the specified time. The delay time units can be changed in the DELAY SCALE field found in each screen of the INPUT DELAY/OUTPUT DELAY function. L MONITOR LEVEL The level of the signal sent from the MONITOR OUT jacks is set by the level (digital) you adjust here together with the level (analog) adjusted by the MONITOR [LEVEL] knob on the top panel of the PM5D. M MONITOR OUT Switches the signal sent from the MONITOR OUT jacks on/off. A SOLO ON/OFF This button selects either 1 CUE mode or SOLO mode as the type of monitoring performed by the [CUE] key. 2 When you turn this button on, a confirmation message will appear. Each mode operates as follows. • CUE mode (SOLO ON/OFF button is off) 3 The signal of the channel whose [CUE] key is pressed will be sent to the dedicated CUE bus, and monitored via the CUE bus from the CUE OUT jacks, MONITOR OUT jacks (if CUE INTERRUPTION is on), and PHONE jack. This mode lets you monitor the signal of a specific channel without affecting other buses. • SOLO mode (SOLO ON/OFF button is on) When using Input Solo, the familiar "solo" function is enabled; only the signal of the channel whose [CUE] key is pressed will be sent to the MIX, MATRIX, and STEREO A/B buses, and other channels will be muted. When using Output Solo, only that channel will be on. The signal of a channel whose [CUE] key is pressed can also be monitored from the CUE OUT jacks, MONITOR OUT jacks, and PHONES jack. B CUE MODE This button selects one of the following two possibilities for when the [CUE] key of more than one channel is pressed. • MIX CUE mode All channels / DCA groups whose [CUE] key is on will be mixed for monitoring. 240 PM5D/PM5D-RH V2 / DSP5D Owner's Manual Reference section