Yamaha DSP5D Owner's Manual - Page 186

SCENE function TRACKING RECALL screen Here you can make settings for the Tracking Recall func- 6 tion, which adds a specified offset value to the value of each fader when you recall a scene. TRACKING RECALL 7 43 1 2 5 A TRACKING RECALL ENABLED/DISABLED Enables/disables the Tracking Recall function. Hint The settings in the TRACKING RECALL screen apply to all scenes. B DISPLAY SELECT These buttons select the type of channels that are shown in the TRACKING RECALL screen; either INPUT (input channels) or OUTPUT (output channels). C SET ALL This button enables Tracking Recall for all channels (including channels not currently shown in the screen). D CLEAR ALL This button disables Tracking Recall for all channels (including channels not currently shown in the screen). E OFFSET LOCK If this button is on, the sliders of all channels (including channels not currently shown in the screen) will be grayed-out, and you will be unable to edit the offset value. F ON (Tracking On) These buttons enable/disable tracking for each channel. If the TRACKING RECALL ENABLED/ DISABLED button is set to ENABLED, tracking is enabled on channels for which this button is ON. Note If OFFSET LOCK (5) is off, turning this button on will reset the tracking offset of the corresponding channel to 0 dB. If in this state you operate the fader of the corresponding channel, the relative amount of fader movement from the point at which this button was turned on will be memorized as the tracking offset. You can then turn OFFSET LOCK on to lock the offset. This offset value will be added whenever you subsequently recall a scene. G Tracking offset Here you can specify the offset value applied to each channel if tracking is enabled. The range is ±15 dB. While OFFSET LOCK (5) is off, operating the panel faders will cause these values to change as well; however, adjusting the offset values in the screen will not cause the panel faders to move. 186 PM5D/PM5D-RH V2 / DSP5D Owner's Manual Reference section