Yamaha DSP5D Owner's Manual - Page 266
ALL PRE FADER [ALL MIX, SELECTED PARAMETER currently selected, parameter
![]() |
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 266 highlights
MATRIX/ST function To change the position from which the signal is sent, move the cursor to the vertical column for the desired channel, and press the [ENTER] key, click, or turn the [DATA] encoder. (The position of all signals sent from that channel to all MATRIX buses will change simultaneously.) If the SEND POINT button is on, the send position for all grid locations can be changed simultaneously. To do so, hold down the [SHIFT] key and click the desired grid. (Alternatively, move the cursor to the desired grid; then hold down the [SHIFT] key and press the [ENTER] key.) When the JOB SELECT window appears, select one of the following choices, and click the OK button. Send level 4 Pan (displayed if the destination MATRIX channel is paired) Position from which the signal is sent On/off switch for the signal sent to the MATRIX bus D SELECTED PARAMETER (currently selected parameter) This area indicates the channel (MIX or STEREO A/B) and MATRIX bus corresponding to the grid where the cursor is currently located. The four boxes at right indicate the values for the grid where the cursor is currently located. ALL PRE FADER [ALL MIX ] All grids will be set to PRE FADER. ALL POST FADER [ALL MIX ] All grids will be set to POST FADER. ALL POST ON [ALL MIX ] All grids will be set to POST ON. 3 C Grid The grid shows various settings for the signals sent from the MIX or STEREO A/B channels (vertical columns) to the MATRIX buses (horizontal rows). The red lines shown in the upward, downward, left, and right directions indicate the channel (MIX or STEREO A/B) and MATRIX bus corresponding to the grid where the cursor is located. 266 PM5D/PM5D-RH V2 / DSP5D Owner's Manual Reference section
![](/manual_guide/products/yamaha-dsp5d-owners-manual-81b84d8/266.png)