Yamaha DSP5D Owner's Manual - Page 281

Information shown in the display Function menu Global functions INSERT/DIRECT OUT POINT screen For each input channel, you can specify the point at which insert in/out will be patched, and the point from which direct output will be taken. Here you can also switch Insert or Direct Output on/off. INSERT/DIRECT OUT POINT 2 3 4 1 A Insert view When you move the cursor to an insert I/O point (4), the insert and direct output locations for that input channel will be shown graphically. 56 B INPUT CH (Input channel) This is the number of the input channel you are editing. Two paired channels are indicated by a heart symbol shown at the left; settings 3-6 will be linked for these channels. You can click this symbol to enable/ disable pairing. C INSERT ON/OFF This button switches insert on/off for each channel. This is linked for two paired channels. Note Be aware that if you turn on this button when either insert-in or insert-out are unpatched, the signal will no longer be output from the corresponding input channel. D INSERT I/O (Insert I/O point) Here you can select one of the following as the insertin/out location for each channel. PRE EQ POST EQ PRE DELAY POST FADER Immediately before the EQ Immediately after the EQ Immediately before the delay Immediately after the fader E SET ALL Turns on the corresponding item (insert or the insert point) for all channels (including channels not currently shown in the screen). F CLEAR ALL Turns insert off for all channels (including channels not currently shown in the screen). Output functions Input functions Appendices PM5D/PM5D-RH V2 / DSP5D Owner's Manual Reference section 281