Yamaha DSP5D Owner's Manual - Page 56
MATRIX channels 1-8, to MATRIX MIX channels and STEREO A/B
![]() |
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
6 Output channel operations MATRIX channels 1-8 The signals sent from MIX channels or STEREO A/B channels to MATRIX buses are sent via these channels to the MATRIX OUT jacks. • 8 BAND EQ (8 band equalizer) (MIX channels and STEREO A/B channels) This is an eight-band (four upper bands + four lower bands) parametric EQ. • 4 BAND EQ (4 band equalizer) (MATRIX channels) This is a four-band (HIGH, HIGH MID, LOW MID, LOW) parametric EQ. • COMP (Compressor) This is a dynamics processor that can be used as a compressor, expander, or limiter. • LEVEL This adjusts the output level of the channel. • ON (On/off) This switches the channel on/off. If this is off, that channel will be muted. • OUTPUT DELAY This delays the output signal. It can be used to make fine adjustments in the relative timing between channels. • OUT ATT. (Output attenuator) This attenuates or boosts the level of the channel's output signal. • METER This meter indicates the output level of the output channel. The level detection point can be switched. • MIX to STEREO (MIX channels) This is an on/off switch for the signal sent from the MIX channel to the STEREO bus. • to MATRIX (MIX channels and STEREO A/B channels) This is an on/off switch for the signal sent from the MIX channel to the MATRIX bus. • PAN (MIX channels) This adjusts the panning of the signal sent from the MIX channel to the STEREO bus. • BAL (Balance) (STEREO channels) This adjusts the L/R volume balance of the STEREO channel. • LCR (Left/Center/Right) (MIX channels) This sends the three-channel signal (left/right channels and a center channel) to the STEREO bus. • INSERT Here you can patch the desired output port and input port to insert-out/insert-in, allowing an external effect processor or other device to be inserted. You can switch the insert-out and insert-in locations. • OUTPUT PATCH Here, output channels can be assigned to output jacks. Hint STEREO A/B channels, and MATRIX channels 1-8 are always connected to STEREO OUT jacks A/B, and MATRIX OUT jacks 1-8 respectively. However, you can also make output patch settings to send the signals of these output channels and MIX channels 1-24 to slots 1-4, the 2TR OUT DIGITAL jacks or the MIX OUT jacks. 56 PM5D/PM5D-RH V2 / DSP5D Owner's Manual Operating section
![](/manual_guide/products/yamaha-dsp5d-owners-manual-81b84d8/56.png)