Yamaha DSP5D Owner's Manual - Page 224
CASCADE ENABLED/DISABLED, DME CONTROL, CASCADE FROM Source when cascade, connected
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 224 highlights
SYS/W.CLOCK function • PM5D-DCU5D - DSP5D-DCU5D - DSP5D This system cascade-connects two DCU5D units and two DSP5D units to the PM5D, adding two sets of 48 remotely located monaural inputs. MJ O K L P Q N J CASCADE ENABLED/DISABLED Turns the Cascade function on/off. Note • If you edit the parameters (9-Q) included in CASCADE CONNECTION or power-cycle the unit, the cascade function will return to the Off state. • If word clock becomes unlocked while machines are synchronized (before cascade connection is enabled), the operation of each machine may become unstable. If this occurs, please power-cycle each machine. • This setting will not be loaded for PM5D firmware V2.0 and later. K DME CONTROL This button accesses the DME CONTROL screen (➥ p.199). The following items L-Q are shown only if you select "PM5D-PM5D" or "PM5D-DCU5D - DCU5DPM5D"as the cascade-connection type. If you select a cascade-connection that includes a DSP5D, the same settings are made automatically, and the settings will be only for viewing. L CASCADE FROM (Source when cascadeconnected) Select one of the following as the external device that is sending audio signals to the PM5D via a cascade connection. Display - PM5D or PM5D+ DCU5D Source device Cascade disabled another PM5D Available cas- Paramecade input port ter linkage CASCADE IN, SLOT 3/4, SLOT 1-4 [CH1-8], SLOT 1-4 [CH9-16] Not possible CASCADE IN Possible*1 Display DM2000 /02R96 MIXER [30BUS] MIXER [16BUS] Source device Yamaha DM2000 or 02R96 A mixer other than the above (maximum 30 bus) A mixer other than the above (maximum 16 bus) Available cascade input port CASCADE IN SLOT 3/4, SLOT 1-4 [CH1-8], SLOT 1-4 [CH9-16] SLOT 4 Parameter linkage Not possible *1. Linked parameters are specified in the CASCADE screen. M CASCADE IN PORT SELECT Select one of the following as the port that will receive the audio signals from the cascade-connected device. Hint • If you select a choice other than CASCADE IN, the signal from the slot will be assigned to the cascade input, and the signal from the CASCADE IN connector will be assigned to the corresponding slot input. • The signal assigned from the CASCADE IN connector to the slot input can be used as a patch source in the IN PATCH screen. • CASCADE IN Up to 30 channels of audio signals can be received from another PM5D via the rear panel CASCADE IN connector. If PM5D is selected as the cascade source (L), control signals for parameter linkage will also be transmitted and received. • SLOT 4 Up to 16 channels of audio signals can be received via input channels 1-16 of an I/O card installed in slot 4 of the rear panel. If you choose this setting, the signals from the CASCADE IN connector (channels 1-16) will be assigned to channels 1-16 of the SLOT IN 4 port instead. CH 1-16 SLOT 4 16 channels CASCADE IN CH 1-16 SLOT 1-3 CH 1-16 CASCADE IN 16 channels SLOT IN 1 (CH 1-16) SLOT IN 2 (CH 1-16) SLOT IN 3 (CH 1-16) SLOT IN 4 (CH 1-16) 224 PM5D/PM5D-RH V2 / DSP5D Owner's Manual Reference section