Yamaha DSP5D Owner's Manual - Page 239
Yamaha DSP5D Manual
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 239 highlights
Information shown in the display Function menu Global functions Output functions the USE AS STEREO BUS button or the USE AS CENTER BUS button is turned on in the STEREO B section of the MIXER SETUP screen (➥ p.222). ❏ If the USE AS STEREO BUS button is on Monitor source L R C ST A STEREO A L STEREO A R ST B STEREO B L STEREO B R - LCR - - ❏ If the USE AS CENTER BUS button is on Monitor source ST A ST B LCR L STEREO A L - STEREO A L R STEREO A R - STEREO A R C - STEREO B L B DEFINE If "DEFINE" is selected in the MONITOR SOURCE section, you can choose the signal that will be monitored from the following. MIX 1-24 MIX bus 1-24 output signal MATRIX 1-8. . . . . . MATRIX bus 1-8 output signal 3 4 5 6 C DIMMER When you turn this button on, the level of the signal being monitored will be temporarily attenuated. The knob adjusts the amount of attenuation that will occur when the button is on. The range of adjustment is -96 dB to 0 dB. While this button is on, the DIMM indicator will appear in the upper right of the display. Hint You can also use an external switch connected to the GPI IN connector to switch the dimmer on/off. To do so, assign the MONITOR DIMMER ON function to the GPI IN port to which the switch is connected. (➥ p.194). D TALKBACK DIMMER This adjusts the amount by which the monitor signal will be attenuated when talkback is on. The range of adjustment is -96 dB to 0 dB. The talkback on/off status is shown in the box below. E CUE INTERRUPTION If this button is on, the cue/solo signal will also be output from the MONITOR OUT jacks while the Cue/ Solo function is active. During this time, the monitor source selected in the MONITOR SOURCE section will be disabled. If this button is off, the cue/solo signal will never be output from the MONITOR OUT jacks. F MONITOR MODE Here you can select one of the following two ways in which the signal will be output from the MONITOR OUT jacks. STEREO . . . . The L/R channels will be output in stereo. MONO . . . . . The L/R channels will be mixed, and output in monaural. The status of these two buttons is linked with on/off operations of the [MONO] key in the MONITOR section of the panel. 9 7 8 G MONITOR INSERT This area shows the input jacks (and input channels of the digital I/O card) that are inserted into the MONITOR OUT L/C/R channels. The input level of the inserted signal is shown by the level meter at the right. If GEQ or EFFECT is inserted, the corresponding information is shown here. H INSERT ON/OFF This button enables/disables insertion. I PATCH Displays the INSERT PATCH screen. Input functions Appendices PM5D/PM5D-RH V2 / DSP5D Owner's Manual Reference section 239