Yamaha DSP5D Owner's Manual - Page 46
CUE] key, TO ST] LED, COMP] LED, GATE] LED, Meter LEDs, DCA assign LEDs, Input channel operations
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
5 Input channel operations I [CUE] key This key lets you cue-monitor the signal of the input channel. J [TO ST] LED This LED will light when the signal sent from the input channel to the STEREO bus is on. K [COMP] LED This indicates the operational status of the compressor for the input channel. This will be dark when the gain reduction amount is 0 dB, dimly lit when it is 0-10 dB, and lit when it is greater than 10 dB. L [GATE] LED This indicates the operational status of the gate for the input channel. This will be dark when the gain reduction amount is 0 dB, dimly lit when it is 0-30 dB (or 0- 10 dB when ducking), and lit when greater than this. M Meter LEDs This is a six-point LED meter that indicates the input level of the input channel. OVER indicates clipping level, and -6 to -60 indicate the level of the signal relative to clipping level (0 dB). The level detection point can be switched. N DCA assign LEDs The LED of the DCA group to which that input channel is assigned will light. O MUTE assign LEDs The LED of the mute group to which that input channel is assigned will light. P [RCL SAFE]/[MUTE SAFE] LEDs The corresponding LED will light when recall safe or mute safe is enabled for the input channel. 46 PM5D/PM5D-RH V2 / DSP5D Owner's Manual Operating section