Yamaha DSP5D Owner's Manual - Page 43
AD IN Items in the AD
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
AD IN section The AD IN section AD-converts the signals that are input from the rear panel INPUT jacks 1-48 and ST IN jacks 1-4, and sends them to the input patch section. The structure of this section differs between the PM5D model and the PM5D-RH model. PM5D model Items in the AD IN section PM5D model 1 2 3 6 4 7 5 5 8 Input channel operations PM5D-RH model DSP5D A [+48V ON/OFF] switch If this switch is on, +48V is supplied to the condenser mic or direct box connected to the INPUT jack 1-48. B [PAD] switch If this switch is on, the input level is attenuated by 26 dB. C [GAIN] knob Adjusts the input sensitivity of the input channel. The range of adjustment is -34 dBu to +10 dBu (when the PAD switch is on) or -60 dBu to -16 dBu (when the PAD switch is off). D [PEAK]/[SIGNAL] LED The [SIGNAL] LED will light when the input level reaches 14 dB below nominal level (i.e., 34 dB below clipping level). The [PEAK] indicator will light when the signal reaches 3 dB below clipping level. E [INSERT ON/OFF] switch This switch enables/disables the INSERT IN/OUT jack located on the rear panel. F ST IN [GAIN] knob Adjusts the input sensitivity of the ST IN channel. The range of adjustment is -34 dBu to +10 dBu. G ST IN [PEAK]/ST IN [SIGNAL] LED The ST IN [SIGNAL] LED will light when the input level of the ST IN channel reaches 14 dB below nominal level (34 dB below clipping level). The ST IN [PEAK] indicator will light when the signal reaches 3 dB below clipping level. H [LAMP DIMMER] knob This adjusts the brightness of the lamp connected to the LAMP connector. PM5D/PM5D-RH V2 / DSP5D Owner's Manual Operating section 43