Yamaha DSP5D Owner's Manual - Page 31
Connections and setup, Examples of systems expanded with the DSP5D
![]() |
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
4 Connections and setup This chapter describes examples of expanded systems using the DSP5D, audio input/output connections, and the setup that will be necessary when starting up the PM5D/DSP5D for the first time. Examples of systems expanded with the DSP5D 4 • In order to use "cascade connections" for expansion, you must first specify the machine ID (➥ p.153) and make cascade connection settings (➥ p.154). If the PM5D and DSP5D are cascade-connected, you'll be able to select the PM5D/DSP5D that will be the target of control from the PM5D's panel (➥ p.40). Connections and setup Example of simple input expansion (PM5D + one DSP5D unit) • This system expands the number of input channels to 96 monaural + 8 stereo. • To make cascade connections, use a D-sub half-pitch 68-pin cable to connect the CASCADE IN connector to the OUT connector of each respective PM5D and DSP5D unit. FoH CASCADE IN OUT IN OUT PM5D CASCADE IN DSP5D PM5D + remotely connected input expansion (PM5D + DCU5D + two DSP5D units) • The connection between the PM5D located at FoH and the DSP5D located on the stage is routed through the DCU5D, via Ethernet CAT5 cable and the CASCADE IN and OUT connectors. • By using two DSP5D units, the number of input channels is expanded to 144 monaural + 12 stereo. • To make cascade connections between the PM5D and DCU5D, use D-sub half-pitch 68-pin cables to connect the CASCADE IN connectors to the OUT connectors of each respective unit. • Connections between the two DSP5D units are made using an Ethernet CAT5 cable and a D-sub half-pitch 68-pin cable, each connected from CASCADE IN to OUT of the two units. Stage IN Ethernet CAT5 OUT IN CASCADE IN CASCADE IN DSP5D IN OUT CASCADE DSP5D Ethernet CAT5 IN OUT POWER DCU5D CASCADE IN OUT OUT FoH PM5D Note If the PM5D and DSP5D are cascade-connected via the DCU5D and you're not synchronizing to an external word clock being input to the PM5D, you should set the PM5D as the word clock master and the DSP5D as the slave. PM5D/PM5D-RH V2 / DSP5D Owner's Manual Operating section 31
![](/manual_guide/products/yamaha-dsp5d-owners-manual-81b84d8/31.png)