Yamaha DSP5D Owner's Manual - Page 77

Inserting an external device into a channel You can insert an effect processor or other external device into the signal route of an input channel or output channel. When doing so, you can specify for each channel the input/output port and insert I/O point that you want to use for insertion. Connecting an external device for insertion When inserting an external device into a desired channel, you can use the rear panel input/output jacks or the input/ output jacks of an I/O card installed in a slot as insert-out/ insert-in jacks. The following diagrams show typical examples of insert connections. Insert connection example 1 Insert connection example 3 Input Patch / Output Patch operations 2 1 2 1 3 3 COAXIAL AES/EBU AES/EBU COAXIAL AES/EBU AES/EBU DIGITAL IN (AES/EBU) Effect processor DIGITAL OUT (AES/EBU) AES/EBU MY8-AE 8 Special AES/EBU cable for MY8-AE Insert connection example 2 MY8-AD96 MY8-DA96 ANALOG OUT ANALOG IN Effect processor INPUT 1/2 (female) DIGITAL OUT (AES/EBU) OUTPUT 1/2 (male) DIGITAL IN (AES/EBU) Effect processor If you are inserting an external digital device via a digital I/ O card as shown in "Insert connection example 3," you will need to synchronize the word clock of the PM5D and the external device. Normally, we recommend that you set the external device as a word clock slave, and make it follow the PM5D's word clock. (For details on how to set your device as a word clock slave, refer to its manual.) Hint For the PM5D model, you can also use the rear panel INSERT IN/OUT jacks to insert an external device into an input signal, as an alternative to the method described above. In this case, the insert I/O point is fixed at immediately before AD conversion. Also, the steps described p.78 will not be necessary. PM5D/PM5D-RH V2 / DSP5D Owner's Manual Operating section 77