Sharp AR M162 AR-M162 AR-M207 Operation Manual Suite - Page 193

PROGRAMMING 11 Press the [OK] key. OK 12 Enter search characters (see "ENTERING CHARACTERS" on page 82). 26 27 28 29 30 A B C D E 31 32 33 34 35 F G H I J 36 37 38 39 40 K L M N O KEY WORDS ABCDE ABC [START]:ENTER Up to 10 search characters can be entered. Only "Uppercase" characters should be used in "KEY WORD" to arrange the addresses in alphabetical order. The search characters function as a keyword if you need to search for the destination when sending a fax. (Page 21) 13 To finish the storing procedure, press the [START] key ( ). If you wish to program an option such as an F-code, chain dialling, transmission speed, or international transmission mode, press the [OK] key. • If you pressed the [START] key ( ), you will return to step 7. If you wish to store another Rapid key or Speed Dial number, repeat steps 7 to 13. If you have finished storing auto-dial numbers, press the [BACK] key. • If you pressed the [OK] key, go to the appropriate page for the option that you wish to program. To program F-code settings, see "F-code settings" which follows. To select "CHAIN DIAL", go to "Chain Dialling" on page 65. To set the "TRANSMISSION SPEED", go to "Transmission speed setting" on page 66. To set the "INTERNATIONAL TRANSMISSION MODE", go to "International transmission mode setting" on page 66. Note About the setting options When storing and editing Rapid keys and Speed Dial numbers, you can also select the setting options below. Chain dialling cannot be combined with any of the other setting options. When you select a setting option, a checkmark appears in the setting option screen. • F-code A sub-address and passcode can be stored for F-code communication. (See below.) • Chain Dialling You can enable or disable Chain Dialling for a Rapid key or Speed Dial number. (Page 65) • Transmission speed You can set the transmission speed to 33,600 bps (maximum speed), 14,400 bps (high speed), 9600 bps (middle speed), or 4800 bps (low speed). The initial setting is 33,600 bps (maximum speed). (Page 66) • International transmission mode . . .The international transmission mode can be set to "OFF" or one of modes 1 to 3. The initial setting is "OFF". (Page 66) [F-code settings] To program F-code settings, complete steps 1 through 13 on pages 62 to 64 and then follow the steps below. 1 Select "SUB ADDRESS" with the [ ] or [ ] key. GH PQR 2-SIDED COPY SPECIAL FUNCTION OTHERS SUB ADDRESS CHAIN DIAL [ ]:CANCEL [START]:ENTER 2 Press the [OK] key. BACK OK GHI 64