Sharp AR M162 AR-M162 AR-M207 Operation Manual Suite - Page 315
Program, Settings, Explanation, CENTER TRAY
View all Sharp AR M162 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 315 highlights
5 KEY OPERATOR PROGRAMS The key operator programs allow the administrator of the machine (key operator) to enable and disable functions to suit the needs of the workplace. This chapter explains the key operator programs for the network and printer functions. For key operator programs for general use of the machine, see the "Key operator's guide". For the initial key operator code set at the factory, see "PROGRAMMING A KEY OPERATOR CODE" in the "Key operator's guide". KEY OPERATOR PROGRAM LIST The key operator programs for the network and printer functions are shown in the following table. Factory default settings are indicated in bold. When "YES, NO" appears in the "Settings" column of a program, the program is enabled by pressing the [OK] key so that a checkmark appears in the checkbox. A checkmark in the checkbox ( ) indicates that "YES" is selected. No checkmark ( ) indicates that "NO" is selected. Note The key operator programs that can be accessed depend on the machine and the options that are installed. Mode NETWORK Program ENABLE DHCP Settings YES, NO PRINTER IP ADDRESS SETTINGS - • IP ADDRESS • SUBNETMASK • DEFAULT GATEWAY ENABLE TCP/IP YES, NO ENABLE NetWare YES, NO ENABLE EtherTalk YES, NO ENABLE NetBEUI YES, NO NOTICE PAGE YES, NO FORCED OUTPUT OF YES, NO PRINT OUTPUT TRAYS CENTER TRAY, UPPER TRAY Explanation Enable this setting if the machine will use an IP address that is assigned by a DHCP server. If DHCP is used, the IP address assigned to the machine may change automatically on occasion. If this happens, printing will not be possible. Change the port setting of the printer driver to the new IP address. If the machine will be assigned a permanent IP address, use these settings to enter the IP address, subnet mask, and default gateway. ☞ SPECIAL SETTINGS (page 33) Select whether or not TCP/IP protocol will be used. Select whether or not NetWare protocol will be used. Select whether or not EtherTalk protocol will be used. Select whether or not NetBEUI protocol will be used. Select whether or not a Notice Page (page 36) is printed when printing is not successful due to a memory full (or other) error. When no tray has the specified size of paper, this setting is used to select whether or not the print job will be printed on the closest size of paper. Specifies the output tray. When the printer driver is used to print, the setting in the printer driver has priority. (This setting is only available if a job separator tray is installed.) 31