Sharp AR M162 AR-M162 AR-M207 Operation Manual Suite - Page 272

HOW TO USE THE NETWORK SCANNER FUNCTION 3 Press the [OK] key. BACK OK You will return to the base screen and the selected resolution will appear in the resolution display. GHI Note Resolution • The default resolution setting is 150 dpi. For typical text documents, a resolution of 200 dpi or 300 dpi produces sufficiently legible image data. (A resolution of 200 dpi corresponds to the generally used "FINE" in fax mode. For this reason, the 600 dpi setting should only be used in cases where high-clarity image reproduction is required, such as an original that includes photographs or illustrations. • When an original is scanned at the maximum resolution (600 dpi), the amount of memory available, the original size, the color mode, and other setting conditions may cause the resolution to change. For information on the setting conditions, see "MAXIMUM RESOLUTION" (page 35). SELECTING THE FILE FORMAT After selecting scan mode and placing the original (steps 1 to 3 on page 20), perform the procedure below. The factory default settings are "PDF" for the file type and "MULTI" for the file creation method (multiple scanned images are combined into one file). If you need to change the file format, follow these steps. 1 Press the [FORMAT] key. When "MULTI" is selected, all scanned images can be combined into a single file, or one file can be created for each page (pages 2 to 6). PER ZOOM AUTO % OUTPUT DUPL OLUTION ADDRESS FORMAT ORIGINAL SIZE DUPLEX OLUTION ADDRESS BROADCAST ORIGINAL SIZE DUPLEX The format selection screen appears. FORMAT PDF PDF G3 MULTI ALL PAGES 1FILE 3 Press the [OK] key. BACK OK You will return to the base screen and the selected format will appear in the file type and file creation method display. GHI 2 Select the file type with the [ ] or [ ] key. GH PQR DUPLEX SPECIAL FUNCTION DUPLEX SCAN The selected file type is highlighted. FORMAT PDF PDF G3 MULTI ALL PAGES 1FILE To set the file creation method, press the [ ] or [ ] key. FORMAT PDF PDF G3 SINGLE 1PAGE 1FILE Note • When the file type is set to "JPEG", the file creation method can only be set to "SINGLE". • To open the scanned image without using the software program in the accompanied CD-ROM, the recipient must have a viewer program that can open the image format (file type) that was selected as explained above. If the recipient cannot open the image, try sending the image in a different format. When "SINGLE" is selected, a one-page file is created for the scanned image. 28