Sharp AR M162 AR-M162 AR-M207 Operation Manual Suite - Page 194

PROGRAMMING 3 Enter a sub-address (maximum 20 digits) with the numeric keys. OK ABC DEF GHI JKL MNO SUB ADDRESS PQRS TUV WXYZ FUNCTION @.-_ :123 ACC. #-C READ-END Characters that can be entered are numbers, " ", "#", and spaces. If you make a mistake, press [C] key and then re-enter the correct number. When this step is referred to in the following procedures, " ", "#", and spaces cannot be entered. • PROGRAMMING AN F-CODE CONFIDENTIAL BOX (step 11 on page 75) • Editing an F-code confidential box (step 17 on page 78) • PROGRAMMING AN F-CODE RELAY GROUP (step 11 on page 76) • Editing an F-code relay group (step 15 on page 79) • PROGRAMMING F-CODE PUBLIC (POLLING MEMORY) BOXES (step 11 on page 77) • Editing an F-code public box (step 15 on page 80) 4 Press the [OK] key. 5 Enter a passcode (maximum 20 digits) with the numeric keys. WXYZ PASS CODE : • Characters that can be entered are numbers, " ", "#", and spaces. If you make a mistake, press [C] key and then re-enter the correct number. • If desired, you can omit the passcode. When this step is referred to in the following procedures, spaces cannot be entered. • PROGRAMMING AN F-CODE CONFIDENTIAL BOX (step 12 on page 75) • Editing an F-code confidential box (step 18 on page 78) • PROGRAMMING AN F-CODE RELAY GROUP (step 12 on page 76) • Editing an F-code relay group (step 15 on page 79) • PROGRAMMING F-CODE PUBLIC (POLLING MEMORY) BOXES (step 12 on page 77) • Editing an F-code public box (step 15 on page 80) 6 Press the [OK] key. When you press the [OK] key, you return to the option setting screen and a checkmark appears to the left of "F-CODE". To cancel the F-code setting, press the key to remove the checkmark. 7 Return to step 13 on page 64. [Chain Dialling] To set an auto-dial number as a Chain Dial number, complete steps 1 through 13 on pages 62 to 64 and then follow the steps below. Note When a number is set as a Chain Dial number, the destination fax number entered in step 8 on page 63 can be up to 48 digits long. 1 Select "CHAIN DIAL" with the [ ] or [ ] key. OTHERS SUB ADDRESS CHAIN DIAL TX SPEED [START]:ENTER • If checkmark appears to the left of "CHAIN DIAL", it is already selected. • To exit, press the [START] key ( ). 2 Press the [OK] key. OK 3 Select "ON" or "OFF" with the [ ] or [ ] key. CHAIN DIAL ON OFF 6 If chain dialling was already selected in step 7 and you wish to cancel the selection, select "OFF". 4 Press the [OK] key. OK After you select "ON" and press the [OK] key, you will return to the option setting screen and a checkmark will appear to the left of "CHAIN DIAL". If you pressed the key, the checkmark will be removed and chain dialling cancelled. 5 Return to step 13 on page 64. 65