Sharp AR M162 AR-M162 AR-M207 Operation Manual Suite - Page 70

CREATING MARGINS WHEN COPYING (Margin shift) The margin shift function shifts the image to create a margin at the edge of the paper. By default the function creates a 1/2" (10 mm) margin at the left edge of the paper. Margin (top) Margin (left edge) AA AA Original Copy Original Copy • You can select whether to create a margin at the top edge or at the left edge of the paper. • Five selections are available for the margin width: 0", 1/4", 1/2", 3/4", 1" (0 mm, 5 mm, 10 mm, 15 mm, 20 mm). (The default setting is 1/2" (10 mm).) • When making two-sided copies, a margin is created at the selected edge on the front side of the paper, and a margin is created on the back side of the paper. • Margin shift cannot be used in combination with 2 in 1 / 4 in 1 copy (page 66). • Margin shift cannot be used in combination with card shot (page 71). • When margin shift is selected, rotating copying will not operate even if the condition for rotate copying is met. • The default margin shift setting can be changed in the key operator programs. (See the "Key operator's guide".) 1 Place the original in the document feeder tray or on the document glass. • When a left-edge margin is selected and you are copying from the document feeder tray, place the original face up so that the margin edge is to the left. When a left-edge margin is selected and you are copying from the document glass, set the original face down so that the margin edge is to the right. • When a top-edge margin is selected, place the original with the margin edge toward the rear of the document feeder tray or the document glass. 2 Press the [SPECIAL FUNCTION] key. DUPLEX SPECIAL FUNCTION DUPLEX SCAN DUPLEX SCAN ACC. SPECIAL FUNCTION SPECIAL MODES ORIG. SIZE ENTER PAPER SIZE SET DISPLAY CONTRAST The function screen appears with "SPECIAL MODES" selected. 4 Press the [OK] key. OK The settings for margin shift will appear. MARGIN SHIFT OFF DOWN RIGHT 1/2 inch (0~1) 5 Select the margin location with the [ ] or [ ] key and select the width with the [ ] or [ ] key. DUPLEX SPECIAL FUNCTION DUPLEX SCAN GH • Select "DOWN" or "RIGHT" for the margin location. PQR • If you select 0" (0 mm), the printed result is the same as when "OFF" is selected. 6 Press the [OK] key. OK You will return to the base screen. 3 Press the [OK] key. BACK OK GHI SPECIAL MODES MARGIN SHIFT ERASE DUAL PAGE COPY [OK]:ADJUST The special modes screen will appear with "MARGIN SHIFT" selected. 68 7 Select other copy settings as needed and press the [START] key ( ). WXYZ To turn off the margin shift function, select the margin shift @.-_ feature again and select "OFF". READ-END