Sharp AR M162 AR-M162 AR-M207 Operation Manual Suite - Page 24

BEFORE USING THE PRODUCT DISABLING (ENABLING) AUTO TRAY SWITCHING When auto tray switching is enabled and paper runs out during copying or printing, the job will continue using paper from a different tray if that tray has the same size of paper in the same orientation. (This function does not operate when using the bypass tray or when a fax is being printed.) This function has been enabled at the factory. If you prefer to disable the function, follow the steps below. 1 Press the [SPECIAL FUNCTION] key. 5 Press the [OK] key. DUPLEX SPECIAL FUNCTION DUPLEX SCAN DUPLEX SCAN ACC. The special function screen will appear. SPECIAL FUNCTION SPECIAL MODES ORIG. SIZE ENTER PAPER SIZE SET DISPLAY CONTRAST The above screen appears in copy mode. 2 Select "PAPER SIZE SET" with the [ ] or [ ] key. GH PQR DUPLEX SPECIAL FUNCTION DUPLEX SCAN SPECIAL FUNCTION SPECIAL MODES ORIG. SIZE ENTER PAPER SIZE SET DISPLAY CONTRAST 3 Press the [OK] key. BACK OK GHI The paper size setting screen will appear. PAPER SIZE SET 8 1 2 x11 R 11x17 11x17 8 1 2 x1 4 8 1 2 x1 3 8 1 2 x1 1 4 Press the [ ] key repeatedly until "AUTO TRAY SWITCHING" appears. PAPER SIZE SET AUTO TRAY SWITCHING OK PAPER SIZE SET AUTO TRAY SWITCHING When a checkmark does not appear in the checkbox, the auto tray switching function will not operate. 6 Press the [ ] key. You will return to the paper size setting screen. PAPER SIZE SET 8 1 2 x 1 1R 11x17 11x17 8 1 2 x 14 8 1 2 x 13 8 1 2 x 11 To re-enable auto tray switching, press the [OK] key in the screen of step 5 so that a checkmark appears. Move the cursor to the lowest tray and then press the [ ] key again. The above screen will appear. 22