Sharp AR M162 AR-M162 AR-M207 Operation Manual Suite - Page 53
Using The Bypass Tray To Copy A Special Size Original
View all Sharp AR M162 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
COPY FUNCTIONS USING THE BYPASS TRAY TO COPY A SPECIAL SIZE ORIGINAL When the bypass tray is being used for copying and an original that is placed on the document glass is detected as being a special size, the display will prompt the user to set the original size. To make a copy in this type of situation, follow the steps below. 1 Load paper in the bypass tray and place the original on the document glass. 2 Touch the [PAPER] key and then select the bypass tray. POSURE PAPER ZOOM AUTO % OUT LOR MODE RESOLUTION ADDRESS FORMAT ORIGIN ROGRAM RESOLUTION ADDRESS BROADCAST ORIGIN [OK]:ORIG. SIZE ENTER AUTO 100% EXTRA A message will appear asking you whether you wish to set the original size or make the copy without setting it. To make a copy without setting the original size, press the [START] key ( ). To set the original size, go to step 3. 3 Press the [OK] key. BACK OK GHI ORIG. SIZE ENTER INCH 8 1 2 x 11R 5 1 2 x 81 2 SIZE INPUT 5 Press the [OK] key. If "SIZE INPUT" was selected in step 4: OK SIZE INPUT SIZE(inch) X: 2 1 2 Y: 21 2 The size entry screen appears and is ready for entry of the width of the original. If you selected AB in step 4, the screen will be Note ready for you to enter the width in AB. If other than "SIZE INPUT" was selected in step 4: You will return to the base screen. Go to step 8. 6 4 Select "X" (width) with the [ ] or [ ] key and enter the width with the [ ] or [ ] key, and then do the same for the length (Y). SIZE INPUT SIZE(inch) X: 8 1 2 Y: 51 2 The original size selection screen appears with "SIZE INPUT" selected. 4 Select inches or AB with the [ ] or [ ] key, and then select the original size with the [ ] or [ ] key. GH PQR DUPLEX SPECIAL FUNCTION DUPLEX SCAN Note • Any number from 2-1/2" to 17" (64 mm to 432 mm) can be entered for the width, and any number from 2-1/2" to 11-5/8" (64 mm to 297 mm) can be entered for the length. • The entered size is retained until the power is turned off, even if "SIZE INPUT" is selected again and the entry screen of step 5 is displayed. 7 Press the [OK] key. OK You will return to the base screen. 8 Press the [START] key ( ). WXYZ Copying begins. @.-_ READ-END 51