Sharp AR M162 AR-M162 AR-M207 Operation Manual Suite - Page 274

HOW TO USE THE NETWORK SCANNER FUNCTION 3 Press the [OK] key. BACK OK GHI 5 Press the [OK] key. OK The set value is stored and you return to the base screen. 4 Select the desired threshold value with the [ ] or [ ] key. B/W THRESHOLD 128 (1~254) The default setting is "128". White becomes stronger as the displayed value approaches "1". Black becomes stronger when the displayed value approaches "254". ENABLING SCANNING MARGINS (VOID AREA) When this function is enabled, margins (void areas that are not scanned) are created around the edges of the machine's maximum scanning area. Select scan mode, place the original (steps 1 to 3 on page 20), and then follow the procedure below. The factory default setting for the void area is "ON" (enabled). If you need to change the void area setting, follow these steps. Void area: 7/64" (2.5 mm) from the top and bottom edges 1/8" (3.0 mm) from the left and right edges 1 Press the [SPECIAL FUNCTION] key in scan mode. Perform this operation from the DUPLEX SPECIAL FUNCTION DUPLEX SCAN DUPLEX SCAN base screen of scan mode. When the [SPECIAL ACC. FUNCTION] key is pressed, the special function menu appears. (To select scan mode, see step 1 on page 20.) 2 Select "VOID AREA" with the [ ] or [ ] key. GH PQR DUPLEX SPECIAL FUNCTION DUPLEX SCAN SPECIAL FUNCTION B/W THRESHOLD LIGHT SOURCE VOID AREA PAPER SIZE SET 3 Press the [OK] key. BACK OK GHI 4 Select "ON" or "OFF" with the [ ] or [ ] key. VOID AREA ON OFF 5 Press the [OK] key. OK The setting is stored and you return to the base screen. 30