Sharp AR M162 AR-M162 AR-M207 Operation Manual Suite - Page 218
Self-diagnostic Function, Messages During Normal Operation
View all Sharp AR M162 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 218 highlights
TROUBLESHOOTING Message (alarm sounds) Toner is low. Add toner. Can not copy or print. [OK]:RETURN Hang up the receiver. Unfold original and return XX original(s) to the document feeder. [START]:CONTINUE Meaning of message Solution Page Toner is low. There is no toner. The extension phone is off-hook. (When an extension phone is connected.) The detected original size is smaller than the actual original size, or a smaller size has been selected. Replace the toner cartridge. Replace the toner cartridge. Replace the extension phone. Place the originals again and make sure that the size indicated in the display is the same as the actual original size. "REPLACING THE TONER CARTRIDGES" in the "Operation manual (for general information and copier)" "REPLACING THE TONER CARTRIDGES" in the "Operation manual (for general information and copier)" - - SELF-DIAGNOSTIC FUNCTION The machine has a self-diagnostic function that automatically stops operation if a problem occurs in the machine. If a problem occurs in fax mode, the following display appears. Message display Call for service. code:xx xx. Main code Sub code Action Turn off the power and then turn it back on. If the error is not cleared, note the 2-digit main code and the 2-digit sub-code and then contact your dealer. MESSAGES DURING NORMAL OPERATION 7 Message Meaning of message SENT No.001 xx% This appears when a direct transmission ends ("xx" indicates the number of pages). P-xxx READING No.001 xx% The original is being scanned into memory (during memory transmission). P-xxx Stand-by. 100% The machine is in the standby state. AUG 22 FRI 10:25 AM ENTER DIAL # This appears when the [SPEAKER] key has been pressed. 89