Sharp AR M162 AR-M162 AR-M207 Operation Manual Suite - Page 216

TROUBLESHOOTING Sending result XX-XX OK NO S ADD FUNC S ADD TX FAIL SA POLL ERR PASSCODE# ERR Explanation When group dialling, broadcast transmission, or F-code relay request transmission was performed, xxx- : Indicates total number of transmissions. xxx OK : Indicates completed transmissions. When an F-code transmission was attempted, (1) The other machine did not have the F-code function. (2) An F-code was not programmed in the other machine. When an F-code transmission was attempted, (1) The sub-addresses did not match. (2) The passcodes did not match. (3) An F-code public box was set. When F-code public box transmission was attempted, (1) The F-code public box specified by the sub-address did not exist. (2) The sub-address specified a box other than an F-code public box. When F-code public box transmission was attempted, (1) The passcodes did not match. Reception result OK P. FAIL MEMORY FULL LENGTH OVER NO RX ROLL RX NO POLL ERRORxx xxxx XX-XX OK NO SA POLLING SA POL TX ERR S ADD RX FAIL JUNK FAX ERR Explanation Reception was completed successfully. The power was turned off or a power failure occurred. The image memory became full during substitute reception to memory. The transmitted document was over 1500 mm long and therefore could not be received. When polling was attempted, (1) Your fax number (sender's number) was not programmed in your machine. (2) Your fax number was not programmed as a polling passcode number in the other machine. When polling was attempted, (1) The other machine did not have a polling function. (2) The other machine did not have a document stored in polling memory. Line conditions prevented the reception from taking place normally. First 2 digits of line error code: Error code from 00 to 31. Last 4 digits of line error code: Code for use by service technicians. When serial polling ended normally, xxx- : Indicates total number of transmissions. xxx OK : Indicates completed transmissions. When F-code polling was attempted, (1) The other machine did not have an F-code polling memory function. (2) An F-code was not programmed in the other machine. (3) The other machine did not have a document stored in polling memory. When F-code polling was attempted, (1) The sub-addresses did not match. (2) The passcodes did not match. (3) The other machine's F-code memory boxes were for F-code relay request transmission or for F-code confidential transmission. When F-code reception was attempted, (1) The sub-addresses did not match or were not programmed. (2) The passcodes did not match or were not programmed. (3) An F-code polling memory box was programmed. Fax reception was denied by the reception denial function. 7 87