Sharp AR M162 AR-M162 AR-M207 Operation Manual Suite - Page 205
S.a. Relay Grp, Sbc Co., Ok]:store Start, Enter Grp Name, Enter Rx Station
View all Sharp AR M162 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 205 highlights
PROGRAMMING [PROGRAMMING AN F-CODE RELAY GROUP] This procedure is used to program an F-code relay group box for relay broadcast of a received fax upon receipt of an F-code relay request. Up to 10 boxes can be programmed. An F-code (sub-address and passcode) for reception of an F-code relay request and the destinations to which the fax is to be relayed are programmed in each box. To check the contents of a programmed box, print the following list: "PRINT REPORT - SUB ADD SET LIST" (page 81). To program an F-code relay group box, follow steps 1 through 6 on page 74 and then follow the steps below. 7 Select an unused box with the [ ] or [ ] key. GH PQR 2-SIDED COPY SPECIAL FUNCTION S.A. RELAY GRP SBC CO [OK]:STORE START 8 Press the [OK] key. BACK OK GHI 9 Enter a name for the F-code relay group box (see "ENTERING CHARACTERS" on page 82). 26 27 28 29 30 A B C D E 31 32 33 34 35 F G H I J 36 37 38 39 40 K L M N O ENTER GRP NAME ABC Up to 36 characters can be entered for the name. A box name must be entered. 10 Press the [OK] key. OK 12 Enter a passcode (maximum 20 digits) with the numeric keys. See steps 5 and 6 on page 65. 13 Enter the relay destinations. Enter full fax numbers with the numeric keys and/or press auto-dial keys (Rapid keys, Speed Dial numbers, and group keys) to select the destinations (page 20). ENTER RX STATION WXYZ 26 27 28 29 : A B C 31 32 33 34 F G H • To clear a mistake when entering a number with the numeric keys, press the [C] key to clear one digit at a time. • A destination selected with a Rapid key, Speed Dial number, or group key is indicated by an icon and a number. To clear an entry, press the [C] key. 14 Press the [OK] key and then dial the fax number of the next destination or press an auto-dial key. BACK OK • After entering a full number with the numeric keys, press the [OK] key to complete the entry. If you pressed an GHI auto-dial key in step 13, it is not necessary to press the [OK] key. You can immediately press another auto-dial key for the next destination. • Repeat steps 13 and 14 until all destinations have been entered. 15 Press the [START] key ( ) to end the procedure. WXYZ @.-_ READ-END 11 Enter a sub-address (maximum 20 digits) with the numeric keys. See steps 3 and 4 on page 65. 76