Cisco MDS-9124 Troubleshooting Guide - Page 225

Chapter 11 Troubleshooting VSANs, Domains, and FSPF VSAN Issues Send documentation comments to [email protected] Step 4 vsan is 2 Beacon is turned off Trunk vsans (allowed active) (1-3,5) Trunk vsans (operational) (1-3,5) Trunk vsans (up) (2-3,5) Trunk vsans (isolated) (1) Trunk vsans (initializing) () 475 frames input, 8982 bytes, 0 discards 0 runts, 0 jabber, 0 too long, 0 too short 0 input errors, 0 CRC, 3 invalid transmission words 0 address id, 0 delimiter 0 EOF abort, 0 fragmented, 0 unknown class 514 frames output, 7509 bytes, 16777216 discards Received 30 OLS, 21 LRR, 18 NOS, 53 loop inits Transmitted 68 OLS, 25 LRR, 28 NOS, 32 loop inits If the trunk is not configured for the VSAN, use the interface command and then the switchport trunk allowed vsan command in interface mode to add the VSAN to the allowed VSAN list for the interface that connects the host and storage devices. E Port Is Isolated in a VSAN Symptom E port is isolated in a VSAN. Table 11-2 xE Port Is Isolated in a VSAN Symptom Possible Cause Solution E port is isolated in a VSAN. E port connecting to the remote switch is isolated. Verify the VSAN. See the "Resolving an Isolated E Port Using Fabric Manager" section on page 11-6 or the "Resolving an Isolated E Port Using Fabric Manager" section on page 11-6. TE port connecting to the remote switch is isolated. See the "Resolving an Isolated ISL Using Fabric Manager" section on page 11-7 or the "Resolving an Isolated ISL Using the CLI" section on page 11-7 Fabric timers misconfigured. Use caution when changing fabric timers. See the "Resolving Fabric Timer Issues Using Fabric Manager" section on page 11-9 or the "Resolving Fabric Timer Issues Using the CLI" section on page 11-9. Port parameters misconfigured. See the "Common Problems with Port Interfaces" section on page 8-13. Zoning mismatch. See Chapter 14, "Troubleshooting Zones and Zone Sets." OL-9285-05 Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x 11-5