Cisco MDS-9124 Troubleshooting Guide - Page 385

Chapter 20 Troubleshooting IP Storage Services FCIP Issues Send documentation comments to [email protected] The FCIP interface will use the local FCIP profile. The FCIP profile binds the FCIP interface to the physical Gigabit Ethernet port and configures the TCP settings used by the FCIP interface. MDS1(config-if)# peer-info ipaddr 10.10.11.2 The IP address in this example indicates the remote endpoint IP address of the FCIP tunnel. MDS1(config-if)# no shutdown MDS1(config-if)# end Displaying the Default Values Using the CLI The following example displays the default values from the show running-config command. MDS1# show running-config Building Configuration ... fcip profile 28 ip address 10.10.10.2 port 3225 tcp keepalive-timeout 60 tcp max-retransmissions 4 tcp pmtu-enable reset-timeout 3600 tcp initial-retransmit-time 100 tcp window-size 64 vsan database vsan 2 name grumpy_02 interface fcip28 no shutdown use-profile 28 peer-info ipaddr 10.10.11.2 ip route 10.10.11.0 255.255.255.0 10.10.10.1 Setting the Static Route for FCIP Tunnels Using the CLI The static route must be set for FCIP tunnels. This route could also be ip route 10.10.11.0 255.255.255.0 interface gigabitethernet 2/8. ips heartbeat ips hapreset ips boot interface GigabitEthernet2/8 ip address 10.10.10.2 255.255.255.0 (This is the IP address used by the FCIP profile.) no shutdown Debugging the Configuration of the Second Switch Using the CLI The following example shows the configuration of a switch (MDS2) with debug mode activated. To activate debug mode for this situation, run the debug ips flow fcip command on a separate terminal. MDS2(config)# fcip profile 28 OL-9285-05 Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x 20-11