Cisco MDS-9124 Troubleshooting Guide - Page 70

Troubleshooting Cisco SAN-OS Software System Reboots Chapter 2 Troubleshooting Installs, Upgrades, and Reboots Send documentation comments to [email protected] Step 9 Usage for bootflash://sup-local 107465728 bytes used 78619648 bytes free 186085376 bytes total Load the system image from the bootflash: files system. switch(boot)# load bootflash:system-image1 Uncompressing system image: bootflash:/system-image1 CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC Would you like to enter the initial configuration mode? (yes/no): yes Note If you enter no, you will return to the switch# login prompt, and you must manually configure the switch. Step 10 Log in to the switch using the password configured in Step 9. switch login:admin Password: Cisco Storage Area Networking Operating System (SAN-OS) Software TAC support: http://www.cisco.com/tac Copyright (c) 2002-2008, Cisco Systems, Inc. All rights reserved. The copyrights to certain works contained herein are owned by other third parties and are used and distributed under license. Some parts of this software may be covered under the GNU Public License or the GNU Lesser General Public License. A copy of each such license is available at http://www.gnu.org/licenses/gpl.html and http://www.gnu.org/licenses/lgpl.html switch# Step 11 Configure the boot variable. switch #config t switch(config)#boot kickstart bootflash:kickstart-image1 switch(config)#boot system bootflash:system-image1 switch(config)#end switch# Step 12 Save the configuration. switch# copy running-config startup-config 100% switch# Recovery for Switches with Dual Supervisor Modules This section describes how to recover when one or both supervisor modules in a dual supervisor switch have corrupted bootflash. 2-22 Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x OL-9285-05