Cisco MDS-9124 Troubleshooting Guide - Page 381

Chapter 20 Troubleshooting IP Storage Services IP Issues Send documentation comments to [email protected] Verification of Switch Connectivity Use the procedures in this section to verify connectivity to a destination switch. Note The FC ID variable used in these procedures is the domain controller address; it is not a duplication of the domain ID. Verifying Switch Connectivity Using Fabric Manager To verify connectivity to a destination switch using Fabric Manager, follow these steps: Step 1 Step 2 Step 3 Choose Fabricxx > VSANxx > Domain Manager to display the domain ID for the destination switch. Concatenate the domain ID with FFFC to obtain the domain controller address. For example, if the domain ID is 0xda(218), the concatenated ID is 0xfffcda. Choose Tools > Ping... to verify reachability to the destination switch. Verifying Switch Connectivity Using the CLI To verify connectivity to a destination switch using the CLI, follow these steps: Step 1 Step 2 Use the show fcdomain domain-list vsan command to display the domain ID for the destination switch. switch# show fcdomain domain-list vsan 200 Number of domains: 7 Domain ID WWN 0x01(1) 20:c8:00:05:30:00:59:df [Principal] 0x02(2) 20:c8:00:0b:5f:d5:9f:c1 0x6f(111) 20:c8:00:05:30:00:60:df 0xda(218) 20:c8:00:05:30:00:87:9f [Local] 0x06(6) 20:c8:00:0b:46:79:f2:41 0x04(4) 20:c8:00:05:30:00:86:5f 0x6a(106) 20:c8:00:05:30:00:f8:e3 Concatenate the domain ID with FFFC to obtain the domain controller address. For example, if the domain ID is 0xda(218), the concatenated ID is 0xfffcda. OL-9285-05 Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x 20-7