D-Link 3324SRi Reference Manual - Page 107
config fdb destination_hit ports, show fdb destination_hit ports {<portlist>}
UPC - 790069256042
View all D-Link 3324SRi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
xStack Gigabit Layer 3 Switch Command Line Interface Manual config fdb destination_hit ports Restrictions Only administrator-level users can issue this command. Example usage: To configure ports 1 to 5 as destination hit ports: DGS-3324SRi:4#config fdb destination_hit ports 1:1-1:5 enable Command: config fdb destination_hit ports 1:1-1:5 enable Success. DGS-3324SRi:4# show fdb destination_hit ports Purpose Syntax Description Parameters Restrictions To view the destination hit port status of ports on the Switch. show fdb destination_hit ports {} This command will allow users to view the destination hit port status of ports listed in the portlist. {} - Specify a port or ports to be displayed. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then the highest switch number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:32:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in numerical order. Entering this command without a specified will allow the user to view the destination hit port status of all ports on the Switch. None. Example usage: To view the destination hit port status: 99