D-Link 3324SRi Reference Manual - Page 79
config syslog host, local7] | udp_port <udp_port_number> | state [enable
UPC - 790069256042
View all D-Link 3324SRi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
xStack Gigabit Layer 3 Switch Command Line Interface Manual config syslog host host. ipaddress − Specifies the IP address of the remote host where syslog messages will be sent. state [enable | disable] − Allows the sending of syslog messages to the remote host, specified above, to be enabled and disabled. Restrictions Only administrator-level users can issue this command. Example usage: To configure a syslog host: DGS-3324SRi:4#config syslog host 1 severity all Command: config syslog host 1 severity all Success. DGS-3324SRi:4##config syslog host 1 facility local0 Command: config syslog host 1 facility local0 Success. DGS-3324SRi:4# config syslog host 1 udp_port 6000 Command: config syslog host 1 udp_port 6000 Success. DGS-3324SRi:4# config syslog host 1 ipaddress 10.44.67.8 Command: config syslog host 1 ipaddress 10.44.67.8 Success. DGS-3324SRi:4# config syslog host 1 state enable Command: config syslog host 1 state enable Success. DGS-3324SRi:4# config syslog host all Purpose Syntax Description Parameters Used to configure the syslog protocol to send system log data to a remote host. config syslog host all [severity [informational | warning | all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port | state [enable | disable]] The config syslog host all command is used to configure the syslog protocol to send system log information to a remote host. all − Specifies that the command will be applied to all hosts. severity − Severity level indicator, as described below: Bold font indicates that the corresponding severity level is currently supported on the Switch. Numerical Severity 71