D-Link 3324SRi Reference Manual - Page 83

xStack Gigabit Layer 3 Switch Command Line Interface Manual To show syslog host information: DGS-3324SRi:4#show syslog host Command: show syslog host Syslog Global State: Disabled Host Id Host IP Address Severity 1 10.1.1.2 All 2 10.40.2.3 All 3 10.21.13.1 All Facility -------Local0 Local0 Local0 UDP port Status 514 Disabled 514 Disabled 514 Disabled Total Entries : 3 DGS-3324SRi:4# config system_severity Purpose Syntax Description Parameters To configure when and where severity messages are to be recorded. config system_severity [trap | log | all] [critical | warning | information] This command is used to configure the system severity levels on the Switch. When an event occurs on the Switch, a message will be sent to the SNMP agent (trap), the Switch's log or both. Events occurring on the Switch are separated into three main categories. • Information - Events classified as information are basic events occurring on the Switch that are not deemed as problematic, such as enabling or disabling various functions on the Switch. • Warning - Events classified as warning are problematic events that are not critical to the overall function of the Switch but do require attention, such as unsuccessful downloads or uploads and failed logins. • Critical - Events classified as critical are fatal exceptions occurring on the Switch, such as hardware failures or spoofing attacks. Choose one of the following to identify where severity messages are to be sent. • trap - Entering this parameter will define which events occurring on the Switch will be sent to a SNMP agent for analysis. • log - Entering this parameter will define which events occurring on the Switch will be sent to the Switch's log for analysis. • all - Entering this parameter will define which events occurring on the Switch will be sent to a SNMP agent and the Switch's log for analysis. Choose one of the following to identify what type of severity warnings are to be sent to the destination entered above. 75