D-Link 3324SRi Reference Manual - Page 269

xStack Gigabit Layer 3 Switch Command Line Interface Manual 30 ARP COMMANDS The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command create arpentry delete arpentry show arpentry config arp_aging time clear arptable Parameters [ | all] {ipif | ipaddress | static} Each command is listed, in detail, in the following sections. create arpentry Purpose Syntax Description Parameters Restrictions Used to make a static entry into the ARP table. create arpentry This command is used to enter an IP address and the corresponding MAC address into the Switch's ARP table. − The IP address of the end node or station. − The MAC address corresponding to the IP address above. Only administrator-level users can issue this command. Example Usage: To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36: DGS-3324SRi:4#create arpentry 10.48.74.121 00-50-BA-00-07-36 Command: create arpentry 10.48.74.121 00-50-BA-00-07-36 Success. DGS-3324SRi:4# delete arpentry Purpose Syntax Description Used to delete a static entry into the ARP table. delete arpentry { | all} This command is used to delete a static ARP entry, made using the create arpentry command above, by specifying either the IP address of the entry or all. Specifying all clears the Switch's ARP table. 261