D-Link 3324SRi Reference Manual - Page 287

xStack Gigabit Layer 3 Switch Command Line Interface Manual create route redistribute dst rip src external protocol. metric − Allows the entry of an OSPF interface cost. This is analogous to a HOP Count in the RIP routing protocol. Restrictions Only administrator-level users can issue this command. Routing information source − OSPF and the Static Route table. Routing information will be redistributed to RIP. The following table lists the allowed values for the routing metrics and the types (or forms) of the routing information that will be redistributed. Route Source OSPF Metric 0 to 16 Static 0 to 16 Type all type_1 type_2 inter+e1 inter+e2 external internal not applicable Entering the Type combination − internal type_1 type_2 is functionally equivalent to all. Entering the combination type_1 type_2 is functionally equivalent to external. Entering the combination internal external is functionally equivalent to all. Entering the metric 0 specifies transparency. Example Usage: To add route redistribution settings: DGS-3324SRi:4#create route redistribute dst rip src ospf all metric 2 Command: create route redistribute dst rip src ospf all metric 2 Success. DGS-3324SRi:4# config route redistribute dst ospf src Purpose Syntax Description Used configure route redistribution settings for the exchange of RIP routes to OSPF routes on the Switch. config route redistribute dst ospf src [static | rip | local] {mettype [1 | 2] | metric } Route redistribution allows routers on the network − that are running different routing protocols to exchange routing information. This is accomplished by comparing the routes stored in the various router's routing tables and assigning appropriate metrics. This information is then exchanged among the various routers according to the individual routers current routing protocol. The switch can redistribute routing information between the OSPF and RIP routing protocols to all routers on the network that are running OSPF or 279