Home » D-Link Manuals » Hubs & Switches » D-Link 3324SRi » Manual Viewer

D-Link 3324SRi Reference Manual - Page 319

disable ospf, show ospf, OSPF Area Aggregation settings

UPC - 790069256042

Add to My Manuals
Save this manual to your list of manuals

Page 319 highlights

xStack Gigabit Layer 3 Switch Command Line Interface Manual DGS-3324SRi:4#enable ospf Command: enable ospf Success. DGS-3324SRi:4# disable ospf Purpose Syntax Description Parameters Restrictions Used to disable OSPF on the Switch. disable ospf This command, in combination with the enable ospf command above, is used to enable and disable OSPF on the Switch. None. Only administrator-level users can issue this command. Usage Example To disable OSPF on the Switch: DGS-3324SRi:4#disable ospf Command: disable ospf Success. DGS-3324SRi:4# show ospf Purpose Syntax Description Parameters Restrictions Usage Example: Used to display the current OSPF state on the Switch. show ospf This command will display the current state of OSPF on the Switch, divided into the following categories: General OSPF settings OSPF Interface settings OSPF Area settings OSPF Virtual Interface settings OSPF Area Aggregation settings OSPF Host Route settings None. None. 311

Section	Page
Introduction	9
	9
	9
Accessing the Switch via the Serial Port	9
Setting the Switch’s IP Address	10
Using the Console CLI	12
	12
	12
Connecting to the Switch	12
Command Syntax	17
Basic Switch Commands	19
Switch Port Commands	34
Port Security Commands	37
Network Management (SNMP) Commands	40
Switch Utility Commands	62
Network Monitoring Commands	68
Multiple Spanning Tree Protocol (MSTP) Commands	85
Forwarding Database Commands	99
Broadcast Storm Control Commands	109
QoS Commands	111
Port Mirroring Commands	124
VLAN Commands	128
Link Aggregation Commands	138
IP Commands (Including IP Multinetting)	144
IGMP Commands (Including IGMP v3)	149
IGMP Snooping Commands	153
MAC Notification Commands	163
Access Authentication Control Commands	168
SSH Commands	193
SSL Commands	201
802.1X Commands	207
Access Control List (ACL) Commands	226
Traffic Segmentation Commands	244
Stacking Commands	247
D-Link Single IP Management Commands	251
Time and SNTP Commands	262
ARP Commands	269
VRRP Commands	273
Routing Table Commands	281
Route Redistribution Commands	285
BOOTP Relay Commands	292
DNS Relay Commands	296
RIP Commands	300
DVMRP Commands	303
PIM Commands	308
IP Multicasting Commands	312
MD5 Configuration Commands	314
OSPF Configuration Commands	317
Route Preference Commands	338
Jumbo Frame Commands	342
File System Commands	344
Command History List	352