D-Link 3324SRi Reference Manual - Page 189

xStack Gigabit Layer 3 Switch Command Line Interface Manual

config authen parameter response_timeout

Purpose

Used to configure the amount of time the Switch will wait for a user

to enter authentication before timing out.

Syntax

config authen parameter response_timeout <int 0-255>

Description

This command will set the time the Switch will wait for a response of

authentication from the user.

Parameters

response_timeout <int 0-255>

- Set the time, in seconds, the Switch

will wait for a response of authentication from the user attempting to

log in from the command line interface or telnet interface. An entry of

0 will denote that the Switch will never time out while waiting for a

response of authentication. The default setting is 30 seconds.

Restrictions

Only administrator-level users can issue this command.

Example usage:

To configure the response timeout for 60 seconds:

DGS-3324SRi:4# config authen parameter response_timeout 60

Command: config authen parameter response_timeout 60

Success.

DGS-3324SRi:4#

Example usage:

To configure the response timeout to never time out:

DGS-3324SRi:4# config authen parameter response_timeout 0

Command: config authen parameter response_timeout 0

Success.

DGS-3324SRi:4#

config authen parameter attempt

Purpose

Used to configure the maximum number of times the Switch will

accept authentication attempts.

Syntax

config authen parameter attempt <int 1-255>

Description

This command will configure the maximum number of times the

Switch will accept authentication attempts. Users failing to be

authenticated after the set amount of attempts will be denied

access to the Switch and will be locked out of further authentication

attempts. Command line interface users will have to wait 60

seconds before another authentication attempt. Telnet users will be

disconnected from the Switch.

Parameters

parameter attempt <int 1-255>

- Set the maximum number of

attempts the user may try to become authenticated by the Switch,

181

Section	Page
Introduction	9
	9
	9
Accessing the Switch via the Serial Port	9
Setting the Switch’s IP Address	10
Using the Console CLI	12
	12
	12
Connecting to the Switch	12
Command Syntax	17
Basic Switch Commands	19
Switch Port Commands	34
Port Security Commands	37
Network Management (SNMP) Commands	40
Switch Utility Commands	62
Network Monitoring Commands	68
Multiple Spanning Tree Protocol (MSTP) Commands	85
Forwarding Database Commands	99
Broadcast Storm Control Commands	109
QoS Commands	111
Port Mirroring Commands	124
VLAN Commands	128
Link Aggregation Commands	138
IP Commands (Including IP Multinetting)	144
IGMP Commands (Including IGMP v3)	149
IGMP Snooping Commands	153
MAC Notification Commands	163
Access Authentication Control Commands	168
SSH Commands	193
SSL Commands	201
802.1X Commands	207
Access Control List (ACL) Commands	226
Traffic Segmentation Commands	244
Stacking Commands	247
D-Link Single IP Management Commands	251
Time and SNTP Commands	262
ARP Commands	269
VRRP Commands	273
Routing Table Commands	281
Route Redistribution Commands	285
BOOTP Relay Commands	292
DNS Relay Commands	296
RIP Commands	300
DVMRP Commands	303
PIM Commands	308
IP Multicasting Commands	312
MD5 Configuration Commands	314
OSPF Configuration Commands	317
Route Preference Commands	338
Jumbo Frame Commands	342
File System Commands	344
Command History List	352

D-Link 3324SRi Reference Manual - Page 189

config authen parameter response_timeout, config authen parameter attempt

Page 189 highlights