D-Link 3324SRi Reference Manual - Page 90

xStack Gigabit Layer 3 Switch Command Line Interface Manual config stp ports forced to half-duplex operation) the p2p status changes to operate as if the p2p value were false. The default setting for this parameter is auto. state [enable | disable] − Allows STP to be enabled or disabled for the ports specified in the port list. The default is enable. Restrictions Only administrator-level users can issue this command. Example usage: To configure STP with path cost 19, hellotime set to 5 seconds, migration enable, and state enable for ports 1-5 of module 1. DGS-3324SRi:4#config stp ports 1:1-1:5 externalCost 19 hellotime 5 migrate yes state enable Command: config stp ports 1:1-1:5 externalCost 19 hellotime 5 migrate yes state enable Success. DGS-3324SRi:4# create stp instance_id Purpose Syntax Description Parameters Restrictions Used to create a STP instance ID for MSTP. create stp instance_id This command allows the user to create a STP instance ID for the Multiple Spanning Tree Protocol. There are 16 STP instances on the Switch (one internal CIST, unchangeable) and the user may create up to 15 instance IDs for the Switch. - Enter a value between 1 and 15 to identify the Spanning Tree instance on the Switch. Only administrator-level users can issue this command. Example usage: To create a spanning tree instance 2: DGS-3324SRi:4#create stp instance_id 2 Command: create stp instance_id 2 Success. DGS-3324SRi:4# 82