D-Link 3324SRi Reference Manual - Page 38

xStack Gigabit Layer 3 Switch Command Line Interface Manual config port_security ports until the Switch has been reset. Restrictions Only administrator-level users can issue this command. Example usage: To configure the port security: DGS-3324SRi:4#config port_security ports 5:1-5:5 admin_state enable max_learning_addr 5 lock_address_mode DeleteOnReset Command: config port_security ports 5:1-5:5 admin_state enable max_learning_addr 5 lock_address_mode DeleteOnReset Success DGS-3324SRi:4# show port_security Purpose Syntax Description Parameters Restrictions Used to display the current port security configuration. show port_security {ports } This command is used to display port security information of the Switch ports. The information displayed includes port security admin state, maximum number of learning address and lock mode. ports − Specifies a port or range of ports to be viewed. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then the highest switch number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in numerical order. None. Example usage: To display the port security configuration: DGS-3324SRi:4#show port_security ports 1:1-1:19 Command: show port_security ports 1:1-1:19 Port# ---1:1 1:2 1:3 1:4 1:5 1:6 Admin State ----------Disabled Disabled Disabled Disabled Disabled Disabled Max. Learning Addr 1 1 1 1 1 1 Lock Address Mode DeleteOnReset DeleteOnReset DeleteOnReset DeleteOnReset DeleteOnReset DeleteOnReset 30