D-Link 3324SRi Reference Manual - Page 300

xStack Gigabit Layer 3 Switch Command Line Interface Manual 36 RIP COMMANDS The RIP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command Parameters config rip enable rip disable rip show rip [ipif | all] {authentication [enable | disable] | tx_mode [disable | v1_only | v1_compatible | v2_only] | rx_mode [v1_only | v2_only | v1_or_v2 | disable] state [enable | disable]} ipif Each command is listed, in detail, in the following sections. config rip Purpose Syntax Description Parameters Used to configure RIP on the Switch. config rip [ipif | all] {authentication [enable | disable] | tx_mode [disable | v1_only | v1_compatible | v2_only] | rx_mode [v1_only | v2_only | v1_or_v2 | disable] state [enable | disable]} This command is used to configure RIP on the Switch. − The name of the IP interface. all - To configure all RIP receiving mode for all IP interfaces. authentication [enable | disable] − Enables or disables authentication for RIP on the Switch. • − Allows the specification of a casesensitive password. tx_mode − Determines how received RIP packets will be interpreted - as RIP version V1 only, V2 Only, or V1 Compatible (V1 and V2). This entry specifies which version of the RIP protocol will be used to transfer RIP packets. The disabled entry prevents the reception of RIP packets. • disable − Prevents the transmission of RIP packets. • v1_only − Specifies that only RIP v1 packets will be transmitted. • v1_compatible - Specifies that only RIP v1 compatible packets will be transmitted. • v2_only - Specifies that only RIP v2 packets will be transmitted. rx_mode − Determines how received RIP packets will be interpreted - as RIP version V1 only, V2 Only, or V1 or V2. This entry specifies which version of the RIP protocol will be used to receive RIP packets. The Disabled entry prevents the 292