D-Link 3324SRi Reference Manual - Page 184

xStack Gigabit Layer 3 Switch Command Line Interface Manual

config authen server_host

for the server host to reply to an authentication request. The default

value is 5 seconds.

retransmit <int 1-255>

- Enter the value in the retransmit field to

change how many times the device will resend an authentication

request when the TACACS, XTACACS or RADIUS server does not

respond. This field is inoperable for the TACACS+ protocol.

Restrictions

Only administrator-level users can issue this command.

Example usage:

To configure a TACACS authentication server host, with port number 4321, a timeout value of 12 seconds and a

retransmit count of 4.

DGS-3324SRi:4#config authen server_host 10.1.1.121 protocol

tacacs port 4321 timeout 12 retransmit 4

Command: config authen server_host 10.1.1.121 protocol tacacs

port 4321 timeout 12 retransmit 4

Success.

DGS-3324SRi:4#

delete authen server_host

Purpose

Used to delete a user-defined authentication server host.

Syntax

delete authen server_host <ipaddr> protocol [tacacs | xtacacs |

tacacs+ | radius]

Description

This command is used to delete a user-defined authentication

server host previously created on the Switch.

Parameters

server_host <ipaddr>

- The IP address of the remote server host to

delete.

protocol

– The protocol used by the server host to delete. The user

may choose one of the following:

Restrictions

Only administrator-level users can issue this command.

±

tacacs

– Enter this parameter if the server host utilizes the

TACACS protocol.

±

xtacacs

- Enter this parameter if the server host utilizes the

XTACACS protocol.

±

tacacs+

- Enter this parameter if the server host utilizes

the TACACS+ protocol.

±

radius

- Enter this parameter if the server host utilizes the

RADIUS protocol.

Example usage:

To delete a user-defined TACACS+ authentication server host:

176

Section	Page
Introduction	9
	9
	9
Accessing the Switch via the Serial Port	9
Setting the Switch’s IP Address	10
Using the Console CLI	12
	12
	12
Connecting to the Switch	12
Command Syntax	17
Basic Switch Commands	19
Switch Port Commands	34
Port Security Commands	37
Network Management (SNMP) Commands	40
Switch Utility Commands	62
Network Monitoring Commands	68
Multiple Spanning Tree Protocol (MSTP) Commands	85
Forwarding Database Commands	99
Broadcast Storm Control Commands	109
QoS Commands	111
Port Mirroring Commands	124
VLAN Commands	128
Link Aggregation Commands	138
IP Commands (Including IP Multinetting)	144
IGMP Commands (Including IGMP v3)	149
IGMP Snooping Commands	153
MAC Notification Commands	163
Access Authentication Control Commands	168
SSH Commands	193
SSL Commands	201
802.1X Commands	207
Access Control List (ACL) Commands	226
Traffic Segmentation Commands	244
Stacking Commands	247
D-Link Single IP Management Commands	251
Time and SNTP Commands	262
ARP Commands	269
VRRP Commands	273
Routing Table Commands	281
Route Redistribution Commands	285
BOOTP Relay Commands	292
DNS Relay Commands	296
RIP Commands	300
DVMRP Commands	303
PIM Commands	308
IP Multicasting Commands	312
MD5 Configuration Commands	314
OSPF Configuration Commands	317
Route Preference Commands	338
Jumbo Frame Commands	342
File System Commands	344
Command History List	352

D-Link 3324SRi Reference Manual - Page 184

config authen server_host, tacacs port 4321 timeout 12 retransmit 4

Page 184 highlights