D-Link 3324SRi Reference Manual - Page 74
show syslog, create syslog host, Syslog Global State: Enabled
![]() |
UPC - 790069256042
View all D-Link 3324SRi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
xStack Gigabit Layer 3 Switch Command Line Interface Manual DGS-3324SRi:4#disable syslog Command: disable syslog Success. DGS-3324SRi:4# show syslog Purpose Syntax Description Parameters Restrictions Used to display the syslog protocol status as enabled or disabled. show syslog The show syslog command displays the syslog status as enabled or disabled. None. None. Example usage: To display the current status of the syslog function: DGS-3324SRi:4#show syslog Command: show syslog Syslog Global State: Enabled DGS-3324SRi:4# create syslog host Purpose Syntax Description Parameters Used to create a new syslog host. create syslog host [] {severity [informational | warning | all] facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port | ipaddress | state [enable | disable] The create syslog host command is used to create a new syslog host. − Specifies that the command will be applied to an index of hosts. There are four available indexes, numbered 1 through 4. severity − Severity level indicator, as shown below: Bold font indicates that the corresponding severity level is currently supported on the Switch. Numerical Severity Code 0 Emergency: system is unusable 66
![](/manual_guide/products/dlink-3324sri-reference-manual-364694b/74.png)