D-Link 3324SRi Reference Manual - Page 146
config ipif, enable ipif, enable ipif {<ipif_name 12> | all}
UPC - 790069256042
View all D-Link 3324SRi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
xStack Gigabit Layer 3 Switch Command Line Interface Manual config ipif Description Parameters Restrictions This command is used to configure the System IP interface on the Switch. - Enter the previously created IP interface name desired to be configured. ipaddress − IP address and netmask of the IP interface to be configured. The address and mask information can be specified using the traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8). vlan − The name of the VLAN corresponding to the previously created IP interface. If a primary and secondary IP interface are configured for the same VLAN (subnet), the user cannot change the VLAN of the IP interface. state [enable | disable] − Allows you to enable or disable the IP interface. bootp − Allows the selection of the BOOTP protocol for the assignment of an IP address to the Switch's System IP interface. dhcp − Allows the selection of the DHCP protocol for the assignment of an IP address to the Switch's System IP interface. Only administrator-level users can issue this command. Example usage: To configure the IP interface System: DGS-3324SRi:4#config ipif System ipaddress 10.48.74.122/8 Command: config ipif System ipaddress 10.48.74.122/8 Success. DGS-3324SRi:4# enable ipif Purpose Syntax Description Parameters Restrictions Used to enable an IP interface on the Switch. enable ipif { | all} This command will enable the IP interface function on the Switch. − The name of a previously configured IP interface the user wishes to enable. Enter an alphanumeric entry of up to twelve characters to define the IP interface. all - Entering this parameter will enable all the IP interfaces currently configured on the Switch. None. Example usage: To enable the ipif function on the Switch: 138