D-Link 3324SRi Reference Manual - Page 245

xStack Gigabit Layer 3 Switch Command Line Interface Manual DGS-3324SRi:4# config traffic_segmentation 1:1-1:10 forward_list 1:11-1:15 Command: config traffic_segmentation 1:1-1:10 forward_list 1:11-1:15 Success. DGS-3324SRi:4# show traffic_segmentation Purpose Syntax Description Parameters Restrictions Used to display the current traffic segmentation configuration on the Switch. show traffic_segmentation The show traffic_segmentation command is used to display the current traffic segmentation configuration on the Switch. − Specifies a range of ports for which the current traffic segmentation configuration on the Switch will be displayed. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then the highest switch number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in numerical order. The port lists for segmentation and the forward list must be on the same switch. Example usage: To display the current traffic segmentation configuration on the Switch. DGS-3324SRi:4#show traffic_segmentation Command: show traffic_segmentation Traffic Segmentation Table Port Forward Portlist 1:1 1:11-1:15,2:1-2:24 1:2 1:11-1:15,2:1-2:24 1:3 1:11-1:15,2:1-2:24 1:4 1:11-1:15,2:1-2:24 1:5 1:11-1:15,2:1-2:24 1:6 1:11-1:15,2:1-2:24 1:7 1:11-1:15,2:1-2:24 1:8 1:11-1:15,2:1-2:24 1:9 1:11-1:15,2:1-2:24 1:10 1:11-1:15,2:1-2:24 1:11 1:1-1:24,2:1-2:24 1:12 1:1-1:24,2:1-2:24 1:13 1:1-1:24,2:1-2:24 1:14 1:1-1:24,2:1-2:24 1:15 1:1-1:24,2:1-2:24 237