D-Link 3324SRi Reference Manual - Page 134
config gvrp, enable gvrp, acceptable_frame tagged_only pvid 2
![]() |
UPC - 790069256042
View all D-Link 3324SRi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
xStack Gigabit Layer 3 Switch Command Line Interface Manual config gvrp Restrictions all − Specifies all of the ports on the Switch. state [enable | disable] − Enables or disables GVRP for the ports specified in the port list. ingress_checking [enable | disable] − Enables or disables ingress checking for the specified port list. acceptable_frame [tagged_only | admit_all] - This parameter states the frame type that will be accepted by the Switch for this function. Tagged_only implies that only VLAN tagged frames will be accepted, while admit_all implies tagged and untagged frames will be accepted by the Switch. pvid - Specifies the default VLAN ID associated with the port. Only administrator-level users can issue this command. Example usage: To set the ingress checking status, the sending and receiving GVRP information : DGS-3324SRi:4#config gvrp 1:1-1:4 state enable ingress_checking enable acceptable_frame tagged_only pvid 2 Command: config gvrp 1:1-1:4 state enable ingress_checking enable acceptable_frame tagged_only pvid 2 Success. DGS-3324SRi:4# enable gvrp Purpose Syntax Description Parameters Restrictions Used to enable GVRP on the Switch. enable gvrp This command, along with disable gvrp below, is used to enable and disable GVRP globally on the Switch, without changing the GVRP configuration on the Switch. None. Only administrator-level users can issue this command. Example usage: To enable the generic VLAN Registration Protocol (GVRP): DGS-3324SRi:4#enable gvrp Command: enable gvrp Success. DGS-3324SRi:4# 126
![](/manual_guide/products/dlink-3324sri-reference-manual-364694b/134.png)