D-Link 3324SRi Reference Manual - Page 87

xStack Gigabit Layer 3 Switch Command Line Interface Manual

DGS-3324SRi:4#disable stp

Command: disable stp

Success.

DGS-3324SRi:4#

config stp version

Purpose

Used to globally set the version of STP on the Switch.

Syntax

config stp version [mstp | rstp | stp]

Description

This command allows the user to choose the version of the

spanning tree to be implemented on the Switch.

Parameters

mstp

– Selecting this parameter will set the Multiple Spanning

Tree Protocol (MSTP) globally on the Switch.

rstp

- Selecting this parameter will set the Rapid Spanning Tree

Protocol (RSTP) globally on the Switch.

stp

- Selecting this parameter will set the Spanning Tree Protocol

(STP) globally on the Switch.

Restrictions

Only administrator-level users can issue this command.

Example usage:

To set the Switch globally for the Multiple Spanning Tree Protocol (MSTP):

DGS-3324SRi:4#config stp version mstp

Command: config stp version mstp

Success.

DGS-3324SRi:4#

config stp

Purpose

Used to setup STP, RSTP and MSTP on the Switch.

Syntax

config stp {maxage <value 6-40> | maxhops <value 1-20> |

hellotime <1-10> | forwarddelay <value 4-30> | txholdcount

<value 1-10> | fbpdu [enable | disable]}

Description

This command is used to setup the Spanning Tree Protocol (STP)

for the entire switch. All commands here will be implemented for

the STP version that is currently set on the Switch.

Parameters

maxage <value 6-40>

−

This value may be set to ensure that old

information does not endlessly circulate through redundant paths

in the network, preventing the effective propagation of the new

information. Set by the Root Bridge, this value will aid in

determining that the Switch has spanning tree configuration

values consistent with other devices on the bridged LAN. If the

79

Section	Page
Introduction	9
	9
	9
Accessing the Switch via the Serial Port	9
Setting the Switch’s IP Address	10
Using the Console CLI	12
	12
	12
Connecting to the Switch	12
Command Syntax	17
Basic Switch Commands	19
Switch Port Commands	34
Port Security Commands	37
Network Management (SNMP) Commands	40
Switch Utility Commands	62
Network Monitoring Commands	68
Multiple Spanning Tree Protocol (MSTP) Commands	85
Forwarding Database Commands	99
Broadcast Storm Control Commands	109
QoS Commands	111
Port Mirroring Commands	124
VLAN Commands	128
Link Aggregation Commands	138
IP Commands (Including IP Multinetting)	144
IGMP Commands (Including IGMP v3)	149
IGMP Snooping Commands	153
MAC Notification Commands	163
Access Authentication Control Commands	168
SSH Commands	193
SSL Commands	201
802.1X Commands	207
Access Control List (ACL) Commands	226
Traffic Segmentation Commands	244
Stacking Commands	247
D-Link Single IP Management Commands	251
Time and SNTP Commands	262
ARP Commands	269
VRRP Commands	273
Routing Table Commands	281
Route Redistribution Commands	285
BOOTP Relay Commands	292
DNS Relay Commands	296
RIP Commands	300
DVMRP Commands	303
PIM Commands	308
IP Multicasting Commands	312
MD5 Configuration Commands	314
OSPF Configuration Commands	317
Route Preference Commands	338
Jumbo Frame Commands	342
File System Commands	344
Command History List	352

D-Link 3324SRi Reference Manual - Page 87

config stp version, config stp, Tree Protocol MSTP globally on the Switch.

Page 87 highlights