D-Link 3324SRi Reference Manual - Page 288

xStack Gigabit Layer 3 Switch Command Line Interface Manual config route redistribute dst ospf src RIP. Routing information entered into the Static Routing Table on the local switch is also redistributed. Parameters src [static | rip | local] − Allows the selection of the protocol of the source device. mettype − allows the selection of one of the methods for calculating the metric value. • Type-1 calculates the metric (for RIP to OSPF) by adding the destination's interface cost to the metric entered in the Metric field. • Type-2 uses the metric entered in the Metric field without change. This field applies only when the destination field is OSPF. metric − Allows the entry of an OSPF interface cost. This is analogous to a Hop Count in the RIP routing protocol. Restrictions Only administrator-level users can issue this command. Routing information source − RIP: the Static Route table, and the Local interface routing information. Routing information will be redistributed to OSPF. The following table lists the allowed values for the routing metrics and the types (or forms) of the routing information that will be redistributed. Route Source RIP Static Local Metric 0 to 16777214 0 to 16777214 0 to 16777214 Metric Type mettype 1 mettype 2 mettype 1 mettype 2 mettype 1 mettype 2 Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed in OSPF as the metric 20. Example Usage: To configure route redistributions: DGS-3324SRi:4#config route redistribute dst ospf src all metric 2 Command: config route redistribute dst ospf src all metric 2 Success. DGS-3324SRi:4# config route redistribute dst rip src Purpose Syntax Used configure route redistribution settings for the exchange of RIP routes to OSPF routes on the Switch. config route redistribute dst rip src [local | static | ospf | [all | i t l | t l | t 1 | t 2 | i t 1 | i t 2]] 280