Home » D-Link Manuals » Hubs & Switches » D-Link 3324SRi » Manual Viewer

D-Link 3324SRi Reference Manual - Page 60

config snmp system_name, enable rmon, DGS-3324SRi Stackable Switch

UPC - 790069256042

Add to My Manuals
Save this manual to your list of manuals

Page 60 highlights

Example usage: xStack Gigabit Layer 3 Switch Command Line Interface Manual To configure the Switch location for "H Q 5 F ": DGS-3324SRi:4#config snmp system_location HQ 5F Command: config snmp system_location HQ 5F Success. DGS-3324SRi:4# config snmp system_name Purpose Syntax Description Parameters Restrictions Used to configure the name for the Switch. config snmp system_name {} The config snmp system_name command configures the name of the Switch. - A maximum of 255 characters is allowed. A NULL string is accepted if no name is desired. Only administrator-level users can issue this command. Example usage: To configure the Switch name for "DGS-3324SRi Stackable Switch ": DGS-3324SRi:4#config snmp system_name DGS-3324SRi Stackable Switch Command: config snmp system_name DGS-3324SRi Stackable Switch Success. DGS-3324SRi:4# enable rmon Purpose Syntax Description Parameters Restrictions Example Usage: To enable RMON: Used to enable RMON on the Switch. enable rmon This command is used, in conjunction with the disable rmon command below, to enable and disable remote monitoring (RMON) on the Switch. None. Only administrator-level users can issue this command. 52

Section	Page
Introduction	9
	9
	9
Accessing the Switch via the Serial Port	9
Setting the Switch’s IP Address	10
Using the Console CLI	12
	12
	12
Connecting to the Switch	12
Command Syntax	17
Basic Switch Commands	19
Switch Port Commands	34
Port Security Commands	37
Network Management (SNMP) Commands	40
Switch Utility Commands	62
Network Monitoring Commands	68
Multiple Spanning Tree Protocol (MSTP) Commands	85
Forwarding Database Commands	99
Broadcast Storm Control Commands	109
QoS Commands	111
Port Mirroring Commands	124
VLAN Commands	128
Link Aggregation Commands	138
IP Commands (Including IP Multinetting)	144
IGMP Commands (Including IGMP v3)	149
IGMP Snooping Commands	153
MAC Notification Commands	163
Access Authentication Control Commands	168
SSH Commands	193
SSL Commands	201
802.1X Commands	207
Access Control List (ACL) Commands	226
Traffic Segmentation Commands	244
Stacking Commands	247
D-Link Single IP Management Commands	251
Time and SNTP Commands	262
ARP Commands	269
VRRP Commands	273
Routing Table Commands	281
Route Redistribution Commands	285
BOOTP Relay Commands	292
DNS Relay Commands	296
RIP Commands	300
DVMRP Commands	303
PIM Commands	308
IP Multicasting Commands	312
MD5 Configuration Commands	314
OSPF Configuration Commands	317
Route Preference Commands	338
Jumbo Frame Commands	342
File System Commands	344
Command History List	352