D-Link 3324SRi Reference Manual - Page 285
Route Redistribution Commands, create route redistribute dst ospf src
![]() |
UPC - 790069256042
View all D-Link 3324SRi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 285 highlights
xStack Gigabit Layer 3 Switch Command Line Interface Manual 33 ROUTE REDISTRIBUTION COMMANDS The route redistribution commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command create route redistribute dst ospf src create route redistribute dst rip src config route redistribute dst ospf src config route redistribute dst rip src delete route redistribute show route redistribute Parameters [static | rip | local] {mettype [1 | 2] | metric } [local | static | ospf {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2}] {metric } [static | rip | local] {mettype [1 | 2] | metric } [local | static | ospf {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2}] {metric } {dst [rip | ospf] src [rip | local | static | ospf]} {dst [rip | ospf] | src [rip | static | local | ospf] Each command is listed, in detail, in the following sections. create route redistribute dst ospf src Purpose Syntax Description Parameters Restrictions Used to add route redistribution settings for the exchange of RIP routes to OSPF routes on the Switch. create route redistribute dst ospf src [static | rip | local] {mettype [1 | 2] | metric } This command will redistribute routing information between the OSPF and RIP routing protocols to all routers on the network that are running OSPF or RIP. Routing information entered into the Static Routing Table on the local xStack switch is also redistributed. src [static | rip | local] − Allows for the selection of the protocol for the source device. mettype [1 | 2] − Allows for the selection of one of two methods of calculating the metric value. • Type-1 calculates (for RIP to OSPF) by adding the destination's interface cost to the metric entered in the Metric field. • Type-2 uses the metric entered in the Metric field without change. This field applies only when the destination field is OSPF. metric − Allows the entry of an OSPF interface cost. This is analogous to a Hop Count in the RIP routing protocol. Only administrator-level users can issue this command. Routing information source − RIP. the Static Route table, and the Local interface routing information. Routing information will be redistributed to OSPF. 277
![](/manual_guide/products/dlink-3324sri-reference-manual-364694b/285.png)