D-Link DES-3828 Product Manual - Page 188
config route redistribute dst rip src
UPC - 790069276811
View all D-Link DES-3828 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 188 highlights
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual Routing information source − RIP: the Static Route table, and the Local interface routing information. Routing information will be redistributed to OSPF. The following table lists the allowed values for the routing metrics and the types (or forms) of the routing information that will be redistributed. Route Source RIP Static Local Metric 0 to 16777214 0 to 16777214 0 to 16777214 Metric Type mettype 1 mettype 2 mettype 1 mettype 2 mettype 1 mettype 2 Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed in OSPF as the metric 20. Example usage: To configure route redistributions: DES-3800:admin#config route redistribute dst ospf src all metric 2 Command: config route redistribute dst ospf src all metric 2 Success. DES-3800:admin# config route redistribute dst rip src Purpose Syntax Description Parameters Used configure route redistribution settings for the exchange of RIP routes to OSPF routes on the Switch. config route redistribute dst rip src [local | static | ospf {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2}] {metric } Route redistribution allows routers on the network that are running different routing protocols to exchange routing information. This is accomplished by comparing the routes stored in the various router's routing tables and assigning appropriate metrics. This information is then exchanged among the various routers according to the individual routers current routing protocol. The Switch can redistribute routing information between the OSPF and RIP routing protocols to all routers on the network that are running OSPF or RIP. Routing information entered into the Static Routing Table on the local switch is also redistributed. src - Allows the selection of the protocol of the source device, as being either local, static or OSPF. After selecting the source device, the user may set the following parameters for that source device from the following options: • all - Specifies both internal an external. • internal - Specifies the internal protocol of the source device. • external - Specifies the external protocol of the source device. • type_1 - Calculates the metric (for RIP to OSPF) by adding the destination's interface cost to the metric entered in the Metric field. • type_2 - Uses the metric entered in the Metric field without change. This field applies only when the destination field is OSPF. 184