D-Link DES-3828 Product Manual - Page 391
config pim crp, create pim static_rp
UPC - 790069276811
View all D-Link DES-3828 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 391 highlights
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual config pim crp Purpose Syntax Description Parameters Restrictions To configure the Candidate RP settings that will determine the RP. config pim crp {holdtime | priority | wildcard_prefix_cnt [0 | 1]} This command will configure parameters regarding the Candidate RP on the Switch, including hold time, priority and wildcard prefix count. This command is for PIM-SM configurations only. holdtime - This field is used to set the time Candidate RP (CRP) advertisements are valid on the PIM-SM enabled network. If CRP advertisements are not received by the BSR within this time frame, the CRP is removed from the list of candidates. The user may set a time between 0 - 255 seconds with a default setting of 150 seconds. An entry of 0 will send out one advertisement that states to the BSR that it should be immediately removed from CRP status on the PIM-SM network. priority - Enter a priority value to determine which CRP will become the RP for the distribution tree. This priority value will be included in the router's CRP advertisements. A lower value means a higher priority, yet, if there is a tie for the highest priority, the router having the higher IP address will become the RP. The user may set a priority between 0 - 255 with a default setting of 0. wildcard_prefix_cnt [0 | 1] - The user may set the Prefix Count value of the wildcard group address here by choosing a value between 0 and 1 with a default setting of 0. Only Administrator or Operator-level users can issue this command. Usage example: To configure the Candidate RP settings for the multiple access network: DES-3800:admin#config pim crp holdtime 150 priority 2 wildcard_prefix_cnt 0 Command: config pim crp holdtime 150 priority 2 wildcard_prefix_cnt 0 Success. DES-3800:admin# create pim static_rp Purpose Syntax Description Parameters Restrictions Used to enter the multicast group IP address used in identifying the Rendezvous Point (RP). create pim static_rp group rp This command will enter the multicast group IP address which will be used to identify the RP. This entry must be a class D IP address. This command is for PIM-SM configurations only. group - Enter the multicast group IP address used in determining the Static RP. This address must be a class D IP address. rp - Enter the IP address of the RP the switch administrator wishes to become the Static RP for this group. Only Administrator or Operator-level users can issue this command. 387