Netgear GS752TS GS7xxTS-TPS Software Admin Manual - Page 126

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches state before forwarding packets. The value must be greater or equal to (Bridge Max Age / 2) + 1. The time range is from 4 seconds to 30 seconds. The default value is 15. • Spanning Tree Maximum Hops. Specifies the maximum number of bridge hops the information for a particular CST instance can travel before being discarded. The valid range is 1-127. 2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch 3. If you make any configuration changes, click Apply to send the updated configuration to the switch. Configuration changes take place immediately. The following table describes the MSTP status information displayed on the Spanning Tree CST Configuration page. Field MST ID VID FID Description Table consisting of the MST instances (including the CST) and the corresponding VLAN IDs associated with each of them. Table consisting of the VLAN IDs and the corresponding FID associated with each of them. Table consisting of the FIDs and the corresponding VLAN IDs associated with each of them. Click Refresh to update the information on the screen with the most current data. CST Port Configuration Use the Spanning Tree CST Port Configuration page to configure Common Spanning Tree (CST) and Internal Spanning Tree on a specific port on the switch. To display the Spanning Tree CST Port Configuration page, click Switching > STP > Advanced > CST Port Configuration. 126